Yamaha XT1200Z 2010 Service Manual page 319

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
c. Check that the cylinder head cover gasket "2"
is installed properly between the cylinder
head cover and the cylinder head.
2
d. Install the electrical components tray bolts.
Refer to "GENERAL CHASSIS" on page 4-1.
L LLL L LLL L L LLL L
4. Tighten:
• Cylinder head cover bolts
Cylinder head cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Tighten the cylinder head cover bolts in stages
and in a crisscross pattern.
5. Install:
• Brake pipe (hydraulic unit to left front brake
caliper)
• Brake pipe (front brake master cylinder to hy-
draulic unit)
• Clutch pipe
6. Install:
• Brake hose holders "1"
Brake hose holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
Be sure to fit the projection "a" on the outer sec-
tion of the brake hose holder into the hole "b" in
the inner section.
1
a b
email: info@motomatrix.co.uk
L LLL L L LLL L L LLL L LLL
1
7. Install:
• Clutch hose holder bolt "1"
Clutch hose holder bolt
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
TIP
Insert the tab "a" on the clutch hose holder into
2
the slot "b" in the frame.
a
b
8. Install:
• Brake hose joint bolt (hydraulic unit to left
front brake caliper) "1"
• Brake hose joint bolt (front brake master cyl-
inder to hydraulic unit) "2"
Brake hose joint bolt (hydraulic
unit to left front brake caliper)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Brake hose joint bolt (front brake
master cylinder to hydraulic unit)
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
TIP
Make sure that the tab "a" on the brake hose
joint bracket contacts the side of the brake hose
joint "b".
b
5-24
CAMSHAFTS
1
a
1