Troubleshooting - Yamaha XT1200Z 2010 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EAS27190

TROUBLESHOOTING

The starter motor fails to turn.
TIP
• Before troubleshooting, remove the following part(s):
1. Right side cowling
2. Right side panel
3. Fuel tank
1. Check the fuses.
(Main and ignition)
Refer to "CHECKING THE FUS-
ES" on page 8-141.
OK ↓
2. Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-142.
OK ↓
3. Check the starter motor operation.
Refer to "CHECKING THE START-
ER MOTOR OPERATION" on page
8-149.
NG ↓
4. Check the starter motor.
Refer to "CHECKING THE START-
ER MOTOR" on page 5-50.
OK ↓
5. Check the relay unit (starting circuit
cut-off relay).
Refer to "CHECKING THE RE-
LAYS" on page 8-145.
OK ↓
6. Check the relay unit (diode).
Refer to "CHECKING THE RELAY
UNIT (DIODE)" on page 8-147.
OK ↓
7. Check the starter relay.
Refer to "CHECKING THE RE-
LAYS" on page 8-145.
OK ↓
8. Check the main switch.
Refer to "CHECKING THE
SWITCHES" on page 8-137.
OK ↓
email: info@motomatrix.co.uk
ELECTRIC STARTING SYSTEM
NG →
Replace the fuse(s).
NG →
• Clean the battery terminals.
• Recharge or replace the battery.
OK →
Starter motor is OK. Perform the electric
starting system troubleshooting, starting
with step 5.
NG →
Repair or replace the starter motor.
NG →
Replace the relay unit.
NG →
Replace the relay unit.
NG →
Replace the starter relay.
NG →
Replace the main switch/immobilizer unit.
8-10