Removing The Abs Unit Cover; Installing The Abs Unit Cover - Yamaha XT1200Z 2010 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EAS23P1103

REMOVING THE ABS UNIT COVER

1. Remove:
• ABS unit cover "1"
TIP
Remove the quick fastener screw "2", and then
pull the ABS unit cover off as shown in the illus-
tration.
2
1
EAS23P1068

INSTALLING THE ABS UNIT COVER

1. Install:
• Frame ground lead "1"
Frame ground lead bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
Make sure that the frame ground lead terminal
"a" contacts the stopper "b" on the frame.
2. Install:
• Plastic locking tie "1"
TIP
• Fold the ABS test coupler lead "2", and then
fasten the ABS test coupler lead, lean angle
sensor sub-wire harness, rear turn signal light
leads, tail/brake light lead, and license plate
light lead with the plastic locking tie.
• Position the plastic locking tie 40–60 mm
(1.57–2.36 in) "a" from the edge of the holder.
email: info@motomatrix.co.uk
b
1
a
GENERAL CHASSIS
3. Install:
• ABS unit cover "1"
TIP
Insert the projections "a" on the ABS unit cover
into the slots "b" in the rear fender assembly, and
then install the quick fastener screw.
a
b
4-7
1
2
a
1