Yamaha XT1200Z 2010 Service Manual page 201

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
M MMM M MMM M M MMM M
a. Insert the front wheel axle from the right side
and tighten it to 72 Nm (7.2 m·kgf, 52 ft·lbf).
b. In the order pinch bolt "1" → pinch bolt "2" →
pinch bolt "1", tighten each bolt to 21 Nm (2.1
m·kgf, 15 ft·lbf) without performing temporary
tightening.
2 1
L LLL L LLL L L LLL L
6. Measure:
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
wheel sensor housing "2")
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
Distance "a" (between the wheel
sensor rotor and wheel sensor
housing)
18.0–18.2 mm (0.71–0.72 in)
1
7. Install:
• Front brake calipers
• Front reflectors (for Oceania)
• Front wheel sensor lead guide (for Europe)
• Front wheel sensor lead holder
• Front wheel sensor
• Front brake hose holder
email: info@motomatrix.co.uk
M MMM M M MMM M M MMM M MMM
L LLL L L LLL L L LLL L LLL
a
2
Front brake caliper bolt
40 Nm (4.0 m·kgf, 29 ft·lbf)
Front wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Front brake hose holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
When installing the front wheel sensor, check
the wheel sensor lead for twists and the sensor
electrode for foreign materials.
ECA23P1012
NOTICE
• Make sure there are no foreign materials in
the wheel hub. Foreign materials cause
damage to the inner sensor rotor and wheel
sensor.
• To route the front wheel sensor lead, refer
to "CABLE ROUTING" on page 2-43.
EWA13500
WARNING
Make sure the brake hose is routed properly.
8. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is installed
properly.
4-28
FRONT WHEEL