Yamaha XT1200Z 2010 Service Manual page 125

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Brake hose (hydraulic unit to rear brake caliper)
2. Rear wheel sensor lead
3. O sensor #1 lead
2
4. O sensor #2 lead
2
5. Crankshaft position sensor lead
6. Rear brake light switch lead
7. Footrest plate
A. Route the crankshaft position sensor lead to the
front of the O sensor #1 lead, and then fasten the
2
leads with the holder.
B. Make sure that there is no slack in the crankshaft
position sensor lead.
C. Route the rear brake light switch lead to the inside
of the frame.
D. Route the rear brake light switch lead to the
outside of the frame.
E. Face the buckle of the plastic locking tie outward
with the end pointing downward and positioned
between the frame and the footrest plate. Do not
cut off the excess end of the plastic locking tie.
F. Route the leads in the order shown in the
illustration.
G. Bend the holder so that the end of the holder is
higher than the line shown in the illustration.
email: info@motomatrix.co.uk
2-64
CABLE ROUTING