General Safety Notes - Formax 7100 Series Operator's Manual

2.1

General safety notes

Installing Important! The machine must be installed only by an authorised
the Service engineer. A safe, level position is necessary, when installing the
machine machine, with sufficient space all round to operate it. The machine is to be
protected from moisture. If moving the machine, ensure that the castor
brakes are off, and push on the stand, not the machine.
Ensure there is at least 1 metre of free space between the operator side of
the machine and a wall or barrier. To provide access to the mains switch, the
opposite side of the machine must be at least 150mm from a wall or barrier.
Do not place surrounding furniture or other objects where your path may be
obstructed.
electrical The machine may only be connected to a voltage of 230V/50Hz or 115V/60
Hz,depending upon model.
danger
The mains plug may only be connected with a socket having an installed
protective contact! The protective effect will be compromised by the use of
an extension line without a protective grounding conductor. All interruptions
of the protective grounding conductor, within or outside of the machine,
are prohibited. The device is double pole fused! When fuse failure occurs,
electrical machine parts can still carry voltage. When making the connection
to the mains power, be aware of the connection values on the nameplate.
Inspect the voltage setting on the device's power input module. Run the
supply lines in such a way, that no-one may trip over them. Do not place any
objects upon the supply line. When the machine is not in use over a long
period of time, it should be disconnected from the power supply. In this way,
damage would be prevented in the event of excess voltage. Protect the device
from moisture. When moisture enters the machine, there is the danger of
electrical shock. Never open the machine except the top cover. For reasons
of electrical safety, the machine may only be opened by authorized Service
Agents.
Operating Never reach into the machine when it is running! This could only occur if a
safety
safety interlock were to fail.
The danger of injuries exists, through pulling in and crushing on the rotating
rollers. In addition, keep long hair and parts of loose clothing far from the
machine in operation. If a safety interlock fails, your Service agent must
be contacted immediately!
In order to prevent damage to the machine, only factory authorized accessory
parts should be used.
Cleaning Prior to cleaning the exterior of the machine, it should be disconnected from
the power supply. When cleaning the machine, do not use liquid or spray
the
cleaners, but only a cloth dampened with water.
machine
Cleaning When cleaning sensors use only non-flammable airdusters, eg. part number
sensors
E0070A. Other types may use flammable propellants, which could result in fire
or explosion.
Caution!
Please, read these notes with care.
Save these instructions for later use.
All notes and warnings found on the machine are to be followed.
5