Panel Unit (For Models With Touch Panel); Panel Unit - Brother DCP-7080 Service Manual

9.14 Panel Unit (For models with touch panel)

9.14.1 Panel Unit

(1) Remove the four taptite cup B M3x10 screws.
(2) Release the claws to remove the panel unit. Disconnect the panel harness from the
panel PCB ASSY.
Note:
• When removing the panel unit, DO NOT pull the panel unit strongly because it is
connected to the panel harness.
Taptite cup B M3x10
Harness routing: Refer to
Assembling Note:
• If you replaced the panel unit, refer to
PANEL PCB UNIT" in Chapter 4
Panel PCB ASSY
Panel harness
Fig. 3-53
"9. Scanner unit".
"4. IF YOU REPLACE THE PANEL UNIT OR
to configure settings.
3-58
Panel unit
Taptite cup B M3x10
Claws
Confidential