Brother DCP-7080 Quick Setup Manual

DCP‑7080 / DCP‑7080D / DCP‑7180DN / MFC‑7380 /
MFC‑7480D / MFC‑7880DN
Quick Setup Guide
Unpack the machine and check the components
A
Drum Unit
(Pre‑installed)
B
Inbox Toner
Cartridge
1
Remove the packing materials and install the toner cartridge
2

Load paper in the paper tray

3

Connect the power cord and turn on the machine

Back
4 Configure the machine for faxing (for MFC models only)
If you do not plan to use the fax feature on this machine, go to step 5.
NOTE:
• To complete fax setup on your machine, see the Basic User's Guide.
• Your machine is programmed to automatically receive faxes. To change this default mode, see the Basic User's Guide.
Connect the telephone line cord
USB Interface Cable Handset, Handset Cord and
Telephone Line Cord (For MFC models)
CD‑ROM Quick Setup Guide, Product Safety Guide
and Basic User's Guide
Remove the orange part.
Adjust the paper guides.
Front
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct
installation procedure.
NOTE:
• The available connection interfaces vary depending on the model.
• The illustrations in this Quick Setup Guide are based on the MFC‑7880DN.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than 2 meters long.
Network cable (DCP‑7180DN / MFC‑7880DN)
Use a straight‑through Category 5 (or greater) twisted‑pair cable for 10BASE‑T or
100BASE‑TX Fast Ethernet Network.
B
A
Remove the orange part.
Version 0
CHN‑ENG
A
B
B
A