Resetting The Lamp Parameters - Barco DP2K-32B Installation Manual

4.6

Resetting the lamp parameters

C
AUTION
the Lamp House. Neglecting this update will result in poor performance and short life time of the xenon lamp.
How to reset the lamp parameters?
1. Start up the projector but do not ignite the lamp.
2. Go via the Communicator touch panel to the menu "Installation" > "Lamp" > "Lamp information".
3. While the Lamp information window is displayed, tap on Reset (1).
A reset message is displayed (2).
4. Tap on Select (3) to display a list of possible article numbers (4). Select a article number (5) and tap OK (6).
The software will validate the selected article number (7).
5. Fill out the serial number of the lamp (8).
6. Click Reset (9).
Image 4-27
Reset lamp info
C
AUTION
Communicator Touch Panel.
R59770491 DP2K-32B 30/04/2010
:
The "LAMP INFO" parameters MUST be updated after each installation of an xenon lamp inside
:
For more information about using the Communicator Touch Panel consult the user's guide of the
4. Lamp & lamp house
47