Installation Of The Xenon Bulb Lamp - Barco DP2K-32B Installation Manual

4. Lamp & lamp house
4.4

Installation of the xenon bulb lamp

W
ARNING
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
W
ARNING
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dismantled or whenever
the protective container or cloth has to be removed from the xenon lamp, authorized protective clothing MUST
be worn!
W
ARNING
W
ARNING
W
ARNING
This procedure assumes that the anode support assembly and the side cover are already removed from the
Lamp House due to the removal of the xenon lamp.
Necessary tools
• Torque wrench with a 2,5 mm Allen socket.
• 1,5 mm Allen wrench.
• 22 mm open-end wrench.
• Torque wrench with a 22 mm hexagon socket.
• Torque wrench with a 5 mm Allen socket.
How to install the xenon lamp
1. Install the appropriate lamp cathode adapter upon the cathode of the xenon lamp. Fasten the set screw of the cathode adapter
with a torque of 2,5 Nm (1,84 lbf*ft). Use a torque wrench with a 2,5 mm Allen socket. Make sure that there is full contact between
the adapter flat surface and the lamp base. Note that some lamp types have a cathode pin with screw thread.
Tip: See "Introduction", page 32, supported xenon bulb lamps to know which cathode adapter your lamp requires.
Warning: Install the cathode adapter prior to removing the protective container or protective cloth from the xenon lamp.
40
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
This procedure may only be performed by qualified technical service personnel.
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield with neck protector) when handling xenon lamps.
:
Always wear protective clothing (welder's jacket) when handling xenon lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon lamps.
R59770491 DP2K-32B 30/04/2010