Adjusting The Camera - Sony PCS-1600 Operating Instructions Manual

Adjusting the Camera

You can adjust the local camera to obtain the best viewing
results.
During communication, you can also adjust the remote camera,
and adjust images being sent from the remote camera.
Notes
• A malfunction may occur if the local and remote parties try to
• You cannot control the remote camera during a meeting if
• You cannot control the remote camera during a meeting if the
• If you adjust the camera angle during a meeting, a motor
To display the picture on the whole screen
While the Camera menu is displayed, to display a full-screen
image, press the PinP button on the Remote Commander to
select the appropriate item on the Camera menu. The picture
will be displayed on the whole screen. To return to the previous
screen, press the joystick, the RETURN button, or the PinP
button on the Remote Commander.
To select the camera to be adjusted
Before adjusting the camera, you must select the local or
remote camera to be controlled.
Press the FAR/NEAR button on the Remote Commander, then
select the far site or near site camera.
When the remote camera is selected, the indication [FAR]
appears on the monitor screen.
When the local camera is selected, the indication [FAR] does
not appear on the monitor screen.
56
Chapter 2 Basic Operation During a Meeting
adjust the same camera at the same time.
H.281 is not selected as the far end camera control protocol.
Compact Processor is used as the MCU.
noise may picked up by the microphone, and it may be heard
through a speaker. This is not a malfunction.
If you frequently adjust the camera, we recommend you to
use the optional PCS-A300 Microphone. If you use a PCS-
A300 microphone, and make the necessary settings changes,
the internal microphone will cease functioning.
For details on the setting when using the PCS-A300
Microphone, see "Audio Setup Menu" on page 108.