Notes On Registration - Sony PCS-1600 Operating Instructions Manual

Registering a Remote Party

Notes on Registration

General note
If the Restrict setting of the remote party is set to 56K in the
Answer Setup menu, the connection will be made at 56 Kbps
even if you set Restrict to Auto in the Dial Setup menu.
Note on the optional PCS-I160 BRI Board
If you have installed the optional PCS-I160 BRI Board, you
can use three ISDN lines (up to 6B channels). In this case,
register second telephone number in the B1 and B2 boxes, and
third telephone number in the C1 and C2 boxes.
Note on the optional PCS-I161 V.35 Board
If the optional PCS-I161 V.35 Board has been installed and
connected to a private line or a terminal adaptor via the V.35
interface, select V.35 in Line I/F, then enter as follows:
• When not using RS-366, set V.35 RS-366 to Off in the Dial
• When using RS-366, set V.35 RS-366 to On in the Dial Setup
To change the ISDN transfer rate temporarily
The Compact Processor is set to 64 Kbps for an ISDN line at
factory. However, some countries (e.g., the USA) or regions
may have 64 Kbps and 56 Kbps ISDN transfer rates. If the
remote party has set its transfer rate to 56 Kbps, you need to set
your system to 56 Kbps to communicate with that system.
Before making a call to such a party, set Restrict to 56K in the
Dial Setup menu.
88
Chapter 4 Registration and Setup
Setup menu. Do not enter the telephone numbers.
menu. Enter the telephone numbers.