Table of Contents
Advertisement
Chapter 4 - Jumper Settings
Clear CMOS Data
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
you can reconfigure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP1 pins 2 and 3 to On. Wait for a few seconds and set JP1 back to its default setting,
pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
Chapter 4 Jumper Settings
Chapter 4
Auto Power-on Select
1
2
3
JP1
1-2 On:
Normal (default)
1
2
3
2-3 On:
Clear CMOS Data
JP15 is used to select the method of powering on the system. If you want the system to
power-on whenever AC power comes in, set JP15 pins 2 and 3 to On. If you want to use the
power button, set pins 1 and 2 to On.
When using the JP15 "Power On" feature to power the system back on after a power failure
occurs, the system may not power on if the power lost is resumed within 5 seconds (power
flicker).
19
1
2
JP15
3
1-2 On:
Power-on via power button
(default)
1
2
3
2-3 On:
Power-on via AC power
www.dfi .com
Advertisement
Table of Contents
