DFI DT122-BE User Manual page 41

MCTP Configuration
This section is used to configure the Management Component Transport Protocol (MCTP).
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
Management Component Transport Protocol (MCTP) Confi guration
Realtek LAN card DASH function [Disabled]
MCTP Support Disabled
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
Realtek LAN card DASH function
Enable or disable the Realtek LAN card DASH function.
When the Realtek LAN card DASH function is enabled, you will enable or disable the
MCTP support.
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
Management Component Transport Protocol (MCTP) Confi guration
Realtek LAN card DASH function [Enabled]
MCTP Support [Disabled]
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
Chapter 7 BIOS Setup
Chapter 7
Realtek LAN card DASH
function Enable/Disable

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
Realtek LAN card DASH
function Enable/Disable

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
41
MCTP Support
Enable or disable the MCTP support.
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
Management Component Transport Protocol (MCTP) Confi guration
Realtek LAN card DASH function [Enabled]
MCTP Support [Enabled]
PLDM for SMBIOS [Enabled]
PLDM for BIOS Control and Confi gure [Enabled]
PLDM for Platform Monitoring [Enabled]
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
PLDM for SMBIOS
Enable or disable the PLDM support for SMBIOS.
PLDM for BIOS Control and Configure
Enable or disable the PLDM support for BIOS control and configuration.
PLDM for Platform Monitoring
Enable or disable the PLDM support for platform monitoring.
Realtek LAN card DASH
function Enable/Disable

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
www.dfi .com