Table of Contents
Advertisement
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system's manual or documentation for more information.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
•
Jumper Setting
JP8, JP9, JP10 and JP11 must be set to "2-3 On: +5V_standby". Refer to "USB Power Select"
in this chapter for more information.
Chapter 5 Ports and Connectors
Chapter 5
Audio
Rear audio
Line-in
Line-out
Mic-in
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
•
Line-in Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player,
AM/FM radio tuner, synthesizer, etc.
•
Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
•
Mic-in Jack (Pink)
This jack is used to connect an external microphone.
Front Audio
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
Driver Installation
Install the audio driver. Refer to the chapter 8 for more information.
26
Front Audio
1
2
Mic2-L
GND
NC
Mic2-R
Line2-R
Mic2-JD
GND
Key
Line2-L
Line2-JD
9
10
www.dfi .com
Advertisement
Table of Contents
