Table of Contents
Advertisement
USB Configuration
This section is used to configure USB parameters.
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
USB Confi guration
USB Devices:
1 Keyboard, 1 Mouse
Legacy USB Support
[Enabled]
USB Mass Storage Driver Support
[Enabled]
Port 60/64 Emulaiton
[Enabled]
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
Legacy USB Support
Enabled
Enable legacy USB.
Auto
Disable support for legacy when no USB devices are connected.
Disabled
Keeps USB devices available only for EFI applications.
USB Mass Storage Driver Support
Enable or disable the USB mass storage driver support.
Port 60/64 Emulation
Enable I/O port 60h/64h emulation support. This should be enabled for the complete
USB keyboard legacy support for non-USB aware OSes.
Chapter 7 BIOS Setup
Chapter 7
NCT6106D Super IO Configuration
This section is used to set the serial port functions.
Enables Legacy USB
support. AUTO option
disables legacy support if
no USB devices are
connected. DISABLE
option will keep USB
devices available only for
EFI applications.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save Changes and
Reset
ESC: Exit
42
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
NCT6106D Super IO Confi guration
NCT6106D Super IO Chip
NCT6106D
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Serial Port 3 Confi guration
Serial Port 4 Confi guration
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
Serial Port 1 Configuration to Serial Port 4 Configuration
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
Advanced
Serial Port 1 Confi guration
[Enabled]
Serial Port
Device Settings
IO=3F8h; IRQ=4;
Change Settings
[Auto]
[Disable]
RS485 Auto Flow Support
Version 2.17.1246. Copyright (C) 2015 American Megatrends, Inc.
Set Parameters of Serial
Port 1 (COMA).
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save Changes and
Reset
ESC: Exit
Enable or Disable Serial
Port (COM).
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save Changes and
Reset
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
