Disassembly And Reassembly; Preparations For Disassembly; Order Of Disassembly - Hitachi DZ-MV350A Service Manual

5

Disassembly and Reassembly

5-1 Preparations for Disassembly

(1) Checking Disc
Connect the AC adapter/charger or charged battery pack, and then press the DISC EJECT button to
make sure that no disc is inserted. After check, close the disc cover.
If the disc cover does not open normally, refer to "4-8 Procedure for Removing Disc from Faulty DZ-
MV350A", and open the holder.
Prohibition
After the above check, disconnect the AC adapter/charger of battery pack from the DZ-MV350A.
The DZ-MV350A has a built-in laser emitter block. Do not look into it: If Laser beam strikes your
eye, it could cause serious damage.
(2) Checking Card
Make sure that no card is loaded in the card slot. After check, close the card slot cover.

5-2 Order of Disassembly

Refer to "Disassembly Flowchart" in Fig. 5-2-1 for the order of removing components. When
reassembling components, use the reverse order to removal unless otherwise specified.
Note:
When replacing components in the DZ-MV350A, be sure to use only those shown in "Replacement
Parts List".
5 - 1