Hitachi DZ-MV350A Service Manual page 42

Troubleshooting > Messages and Troubleshooting
Message
Data error in all image file.
Repair all data now?
YES NO
DISC ACCESS
DISC ALMOST FULL
Disc error
Disc error has occurred.
Finalizing is not complete.
Disc error has occurred.
Format the disc now?
YES NO
Cause/condition for
message to appear
Appears if writing to file cannot be
completed normally because power was
turned off by mistake during video
recording or editing, and it is recognized
that the video file must be totally
repaired.
Also appears when condensation occurs
on lens or drive of DZ-MV350A.
Condensation will occur when the DZ-
MV350A is moved form a cold place to a
warm place.
This message appears during normal
operation process, when DZ-MV350A
checks whether a proper disc has been
loaded or not. It is displayed for a longer
time period when the date has changed.
This message appears during normal
operation process, when the recorded
images are being stored on disc.
Appears if the remaining video
recordable time on disc is less than 10
minutes, or the remaining number of
recordable photos is less than 10.
Appears when the disc has been edited
on a device other than DZ-MV350A, and
mismatch has occurred in recorded data.
Also appears when reading or writing
from/to recorded file cannot be performed
because the disc is dirty.
Appears when the disc could not be
finalized because it was dirty.
Appears if accident, such as power off,
has occurred during finalizing.
If the message still appears even when
the disc has been cleaned and finalized
again and again, the disc may be
defective.
Appears when a DVD-RAM disc
initialized on PC, etc., or a card whose
initialization was suspended before, is
loaded.
4 - 13
Troubleshooting
Choose "YES" and designate total
repair (automatic repair) of video file.
Choosing "NO" will display a
message for verifying initialization.
[Refer to *3 on page 4-12]
Do not execute repair, but set the
power switch to "POWER OFF" with
the disc loaded, and then leave the
DZ-MV350A in a dry place until
condensation disappears (usually 1-2
hours).
Operate DZ-MV350A after the
message disappears.
Operate DZ-MV350A after the
message disappears.
Delete unnecessary scenes, or replace
the disc.
Format the disc (deleting all recorded
data), or replace the disc.
Clean the disc, or replace it.
[Refer to page 4-12]
Clean the disc, or replace it.
[Refer to page 4-12]
Set the power switch to "POWER
OFF" and reconnect the AC adapter/
charger; then set the power switch to
"VIDEO" and start finalizing again.
Or press the DISC EJECT button,
reload the disc, and then execute
finalizing.
Replace the disc.
Choose "YES" and designate it to
initialize the DVD-RAM disc
(deleting all recorded data).