Hitachi DZ-MV350A Service Manual page 40

Troubleshooting > Messages and Troubleshooting
Message
Cannot record photos.
Cannot replace thumbnail
on PHOTO scenes.
CARD ALMOST FULL
Card error has occurred.
Format the card now?
Card error has occurred.
Formatting is not complete.
Card error has occurred.
Keep card inside & restart.
Card error.
Card full.
Card full.
Cannot execute.
Card is not formatted.
Format the card now.
YES NO
CHECK DISC
Cause/condition for
message to appear
Appears if an attempt is made to record
photos on DVD-R disc: The specifications
state that no photo is recordable on
DVD-R disc.
Appears when a photo thumbnail was
selected for change in scene editing
menu: The specifications stipulate that
the thumbnail of photo cannot be
changed.
Appears when the remaining recordable
number of photos is less than 10 during
recording.
Appears when a card initialized on PC,
etc., or a card whose initialization was
interrupted before, is loaded.
Appears when a damaged card is
initialized.
Appears when no photo could be recorded
on card normally.
Appears when the card cannot be
recognized because its terminals are
dirty.
Also appears when data other than
photos is recorded on card.
Appears when the recording capacity of
card has reached the limit during
recording.
Appears when a card whose remaining
recording capacity is small, and on which
no photo can be recorded, is loaded.
Appears when the remaining capacity of
card has reached the recordable limit.
Appears when an unformatted card or a
card formatted on PC was loaded.
Appears when disc that cannot be used
on the DZ-MV350A, or logically damaged
disc (warped or distorted), was loaded.
If the type of disc is acceptable, and
there is no scratch or distortion, the disc
may be defective.
4 - 11
Troubleshooting
Use a DVD-RAM disc or card when
recording photos.
Select a video to change the
thumbnail.
Prepare another card, or delete
unnecessary photos.
Choose "YES" and designate it to
initialize the card (deleting all
recorded data).
Replace the card.
Set the power switch to "POWER
OFF", and after several seconds, set
it to "[CARD]PHOTO".
Initialize the card (deleting all
recorded data).
Use a dry cloth to clean the card
terminals.
Replace the card.
Replace the card, or delete
unnecessary photos
.
Replace the card, or delete
unnecessary photos.
Replace the card, or delete
unnecessary photos.
Choose "YES" and designate it when
formatting card (deleting all recorded
data).
Check the type of disc, and for scratch
or distortion on disc: If the disc is
scratched or distorted, replace it.
Replace the disc.