System Reset Procedure; Procedure For Resetting Camera Functions - Hitachi DZ-MV350A Service Manual

Troubleshooting > System Resetting/Resetting Camera Functions
System
Item
reset
Date Mode Yes
Date Set Yes
Brightness Yes
Color Level Yes
Beep Yes
Power Save Yes
Record LED Yes
Language Yes
Demo Mode Yes
Note Column

4-2-2 System reset procedure

1) Set the power switch to "POWER OFF", and then disconnect
the battery or AC adapter/charger.
2) Use a fine tipped pen, etc. to hold down the RESET button for
approx. 2 seconds.

4-2-3 Procedure for resetting camera functions

1) Connect the battery or AC adapter/charger to power the DZ-MV350A.
2) Set the power switch to "VIDEO" and place the DZ-MV350A in the recording pause status;
loading disc is not necessary at this time. For the following steps, operate DZ-MV350A while
viewing the LCD monitor or viewfinder.
3) Press the MENU button to display the camera setting menu screen.
4) Use the joystick to choose "Initial Setup", and then press the playback/pause button (press the
center of joystick).
5) Use the joystick to choose "Reset", and then press the playback/pause button: The screen for
verifying reset will appear.
6) Use the joystick to choose "YES", and then press the playback/pause button: Reset will be
executed.
7) After reset, press the MENU button to close the camera setting menu.
Table 4-2-1 Settings to Be Reset (2/2)
Camera
Default at
function
factory
reset
Date Setup
Yes month/day/ year/month/day PM5:00,
year month/day/year 5:00PM,
day/month/year 17:00
No 01/01/2003
12:00AM
LCD Setup
Yes Center
Yes Center
Initial Setup
Yes On On, Off
Yes Off On, Off
Yes On On, Off
Yes English English, French,
Spanish, German, Italian
Yes Auto Auto, Off, Start
4 - 3
Setting range Remarks
-----------------
+
Fig. 4-2-1 System Reset
Yes: Will be reset
No: Will not be reset
Memo
RESET Button