Hitachi DZ-MV350A Service Manual page 47

Troubleshooting > Messages and Troubleshooting
Message
Scenes over limit.
Cannot add scenes.
Scenes over limit.
Cannot divide scenes.
Scenes over limit.
Cannot move scenes.
Selected scenes over limit.
Cannot select scenes any
more.
Stop processing.
There is no scene to which
DPOF is set.
There was no scene which
can be deleted.
This disc cannot be used.
Please replace disc.
This disc is recorded by the
PAL system.
Please replace disc.
Top scenes cannot be
divided.
Cause/condition for
message to appear
Appears if an attempt is made to register
a new scene in play list, with the
specified 999 upper limit scenes
registered. [Refer to *1 page 4-10]
Appears if an attempt is made to divide a
scene with the specified 999 upper limit
scenes registered, or the number of
scenes will exceed 999 with division.
[Refer to *1 page 4-10]
Appears if an attempt is made to move a
scene at the upper limit of 999 scenes
registered, or the number of scenes will
exceed 999 by moving a scene. [Refer to
*1 page 4-10]
Appears when the number of scenes
selected on card has exceeded the upper
limit of 999 scenes.
This message appears during operation
process. It will appear when user
interrupted any process by pressing the
stop/cancel button when processing
multiple scenes, etc.
Appears if "Slide Show: DPOF" is
specified when a card for which DPOF
has not been set is loaded.
Appears when only multiple locked
scenes were selected using the Disc
Navigation function, and deleting them
was attempted.
Appears when a type of disc that cannot
be used on DZ-MV350A was loaded.
Appears when a disc recorded in the PAL
system was loaded: The DZ-MV350A is
exclusively for the NTSC system and
does not comply with the PAL system.
Appears when the first image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its top is not possible.
4 - 18
Troubleshooting
Delete unnecessary scenes from play
list before adding a new scene to it.
Delete unnecessary scenes before
dividing a scene.
Delete unnecessary scenes before
moving scenes.
Release the selection of unnecessary
scenes.
Operate DZ-MV350A after the
message disappears.
Specify "Slide Show: All", or do not
try slide show.
Use the Disc Navigation function to
unlock the scenes, and then restart
operation.
Check the type of disc and insert a
disc usable on DZ-MV350A.
Use a disc recorded in the NTSC
system.
Stop trying to divide a scene.