Table of Contents
Advertisement
Adjustment > Setups for Adjustment
6-2-6 Starting and Terminating Adjustment Program
The adjustment program will not start unless the connections for adjustment are correct, and the
DVD video camera/recorder or DSP-R jig is powered. Make sure that the connections are correct, the
power switch on DVD video camera/recorder is set to "VIDEO", and the DC power supply for DSP-R
jig is turned on.
Information:
1) Display ×××× on subsequent PC screen shows the model name.
2) The numbers on PC screens show the operational procedure.
(1) Start
1) Start the PC. If the PC has already started, terminate
all other applications.
2) Start Explorer, and double-click the "MAP2003W.EXE"
file in map03w folder to start the adjustment program.
3) Once the adjustment program has started, the
COMMUNICATION PORT SETTING screen will
appear.
4) Check the communication port to which the RS-232C
cable is connected, and then choose the radio button of
corresponding port on COMMUNICATION PORT
SETTING screen.
5) Click the OK button on the COMMUNICATION PORT
SETTING screen, and then proceed with the MODEL
SELECT screen.
Note:
If the POWER OR CONNECTION ERROR dialog appears ,
perform the following procedure:
1) Make sure that the connections for adjustment are
correct, and that the DVD video camera/recorder or
DSP-R jig is powered.
2) If there is a problem in connections or power supply,
take care of the problem, and then click the YES button
to proceed with the MODEL SELECT screen.
If there is no problem in connections or power supply,
the indication will be that the incorrect communication
port has been chosen. Click the NO button in POWER
OR CONNECTION ERROR dialog to proceed with the
COM PORT ERROR dialog: Click the OK button, and
then choose the correct communication port.
COMMUNICATION PORT SETTING
screen
MANUAL ADJUSTMENT PROGRAM for SERVICE STATION
MANUAL ADJUSTMENT PROGRAM
4
5
POWER OR CONNECTION ERROR
dialog
ERROR
MAY OCCURE ON CABLE OR JIG OR CAMCORDER.
POWER FAILURE OR CONNECTION ERROR!
COM PORT ERROR dialog
ERROR
!
COM PORT ERROR
6 - 16
for SERVICE STATION
COM PORT SETTING
PORT
PORT 1
PORT 4
PORT 5
PORT 2
PORT 3
PORT 6
EXIT
OK
Copyright (C) HITACHI, Ltd 2003
NO
YES
OK
Advertisement
Table of Contents
Troubleshooting
