HUSABERG FE 450 Repair Manual page 20

DISMOUNTING AND MOUNTING THE ENGINE
– Mount the clutch slave cylinder (1) and tighten the
bolts to 6 Nm.
– Position the chain and mount the chain joint (2).
– Connect the generator and pickup connector (3) and
fasten the wiring harness to the clutch line with cable
clips.
– Mount the bolt for the push rod holder (4) and secure
with the retaining clip.
– Position the foot brake lever, secure the bearing bolt
(5) with Loctite 243 and tighten the bearing bolt to
10 Nm.
– Screw on the frame protector (6) and secure with cable
clips.
– Slide the radiator into the frame from the right and
screw on with the 3 nuts (7).
– Mount the engine vent hose (8) and tighten the hose
clamps.
2
3
4
5
7
8
1
6
7
7
B
7