Mounting The Engine - HUSABERG FE 450 Repair Manual

DISMOUNTING AND MOUNTING THE ENGINE

MOUNTING THE ENGINE

– Lift the engine into the frame, position the engine
mounting plates (1), insert the bolts and screw on the
nuts but do not tighten yet.
– Position the swing arm and push in the swing arm
pivot (2) from the right until it touches the engine.
– Lift the engine until the swing arm pivot can be
pushed through the engine case, gently tapping with a
plastic hammer if necessary.
– Screw the nut on the swing arm pivot and tighten to
100 Nm.
– Tighten the nuts on the engine mounting plates to
25 Nm.
– Insert the carburetor in the front carburetor connection
boot and tighten the clamps.
– Mount the rear carburetor connection boot (3) and
tighten the clamps
1
2
B
5
3