Throttle Cable Free-Play; Engine Rpm (Idle); Gas Tank - Arctic Cat 2015 XR Service Manual

INSTALLING
1. Install the throttle body into the intake pipe and
secure with the clamp. Tighten securely.
2. Install the air filter housing boot and secure with the
two hose clamps.
3. Connect the four electrical connectors to the throttle
body components.
4. Connect the throttle cable to the throttle body and
adjust throttle cable free-play (see Throttle Cable
Free-Play in this section); then connect the gasline
hose.
5. Install the actuator cover to the throttle body and
secure with the two screws.
 NOTE: The longer screw goes on top.
6. Connect the battery (positive cable first); then install
the side panels and seat making sure it locks securely
in place.
 NOTE: If the throttle body, ECM, TPS, or ISC are
replaced, the EFI system must be synchronized. Use
the following procedure.
1. With the key off, depress accelerator pedal to Wide
Open Throttle (WOT).
2. Place the ignition key in the ON position and wait for
10 seconds.
3. Release the accelerator pedal, and wait an additional
10 seconds.
4. Turn the key to the OFF position and allow the gauge
to shut off.

Throttle Cable Free-Play

To adjust the throttle cable free-play, follow this proce-
dure.
1. Slide the rubber boot away; then loosen the jam nut
from the throttle cable adjuster.
2. Turn the adjuster until the throttle cable has proper
free-play of 3-6 mm (1/8-1/4 in.) at the lever.
3. Tighten the jam nut against the throttle cable adjuster
securely; then slide the rubber boot over the adjuster.

Engine RPM (Idle)

 NOTE: The idle RPM is not adjustable on the EFI
models.
Whenever any maintenance or inspection is made on
the fuel system during which there may be fuel leakage,
there should be no welding, smoking, open flames, etc.,
in the area.
REMOVING
1. Remove the seat and side panels; then remove the
rear body panel/rack.
2. Disconnect the fuel pump connector and gasline hose
from the fuel pump.
3. Remove the cable ties securing the vent hose to the
frame.
4. Remove the two cap screws securing the gas tank
mounting tab to the frame.
CF297A

Gas Tank

! WARNING
XR124A
XR126A
115