Throttle Cable Free-Play - Arctic Cat ATV 250 Utility 2009 Service Manual

INSTALLING
1. Connect the vent hose onto the carburetor.
2. Place the throttle cable into position and secure by
tightening the outer jam nut.
3. Connect the throttle cable to the actuator arm.
4. Place the throttle actuator cover into position on
the carburetor; then secure with the screw.
Back
4-6
KC0019A
PR162B
PR162C
Back to TOC
5. Connect the choke assembly to the carburetor.
6. Install the air filter; then tighten the clamp secur-
ing the air inlet boot to the carburetor. Secure the
air filter housing to the frame with the cap screws.
7. Install the gas tank; then install the seat.

Throttle Cable Free-Play

To adjust throttle cable free-play, use the following
procedure.
1. Slide the rubber boot away from the adjuster; then
loosen the jam nut (1) from the throttle cable
adjuster (2).
2. Turn the adjuster until the throttle cable has proper
free-play of 1-4 mm (1/16-3/16 in.) at the lever.
Back to Section TOC
PR154B
KM111A
ATV-0047B
Next