Rear Sway Bar - Arctic Cat 2015 XR Service Manual

4. Apply grease on the drive axle splines; then install
the hub assembly onto the drive axle.
5. Secure the hub assembly with the nut. Tighten only
until snug.
6. Secure the brake caliper to the knuckle with two new
"patch-lock" cap screws (right side only). Tighten
the caliper to 20 ft-lb.
 NOTE: Ensure the brake hose is properly routed
and secured to the upper A-arm with the clips tight-
ened to 40 in.-lb.
7. Compress the hand brake lever and engage the brake
lever lock; then tighten the hub nut (from step 5) to
ft-lb.
8. Install a new cotter pin and spread the pin to secure
the nut.
 NOTE: If the cotter pin does not line up, always
tighten to the next alignment.
9. Secure the shock absorber to the frame and A-arm
with a cap screw and new lock nut. Tighten to 50
ft-lb.
PR290
10. Install the wheel and tighten the wheel nuts in 20 ft-lb
increments to a final torque of 40 ft-lb (steel wheel),
60 ft-lb (aluminium wheel w/black nuts), or 80 ft-lb
(aluminum wheel w/chrome nuts).
11. Remove the ATV from the support stand.

Rear Sway Bar

REMOVING
1. Remove and discard the cap screws and lock nuts
securing the sway bar link to the lower A-arms on
both sides.
XR096B
2. Remove the cap screws securing the sway bar to the
frame and remove the sway bar. Account for the
bushing retainers and bushings.
XR099
XR101A
XR096C
171