Engine Rpm (Idle); Throttle Cable Free-Play - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
3. Connect the throttle cable to the actuator arm.
4. Place the throttle actuator cover into position on the
carburetor; then secure with the screw.
5. Connect the choke assembly to the carburetor.
6. Install the air filter; then tighten the clamp securing
the air inlet boot to the carburetor. Secure the air fil-
ter housing to the frame with the cap screws.
7. Install the gas tank; then install the seat.

Throttle Cable Free-Play

To adjust throttle cable free-play, use the following pro-
cedure.
1. Slide the rubber boot away from the adjuster; then
loosen the jam nut (1) from the throttle cable adjuster
(2).
PR162B
2. Turn the adjuster until the throttle cable has proper
free-play of 1-4 mm (1/16-3/16 in.) at the lever.
PR162C
3. Tighten the jam nut against the throttle cable adjuster
securely; then slide the rubber boot over the adjuster.
To properly adjust the idle RPM, a tachometer is neces-
sary. To adjust idle RPM, use the following procedure.
 NOTE: The idle adjustment screw is located on the
right side of the carburetor.
1. With the transmission in neutral, start the engine and
warm it up to normal operating temperature.
2. Turn the idle adjustment screw clockwise one turn
PR154B
past the recommended RPM setting; then turn it
counterclockwise to the correct setting of 1250-1350
RPM.
Adjust the idle to the correct RPM. Make sure the engine
is at normal operating temperature before adjusting the
idle RPM.
www.mymowerparts.com
Manual
Table of Contents

Engine RPM (Idle)

! WARNING
KM111A
ATV-0047B
67