Throttle Cable Free-Play; Engine Rpm (Idle) - Arctic Cat 2012 DVX 90 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Install the carburetor onto the intake manifold; then
tighten the cap screws securely.
5. Install the air intake boot between the air filter and
the carburetor. Secure with the clamp.
6. Install the float chamber drain hose and the vent hose
to the carburetor.
www.mymowerparts.com
7. Install the gas hose onto the carburetor.
CD591

Throttle Cable Free-Play

To adjust the throttle cable free-play, use the following
procedure.
1. Pull back rubber boot to access cable adjustment nut.
CD592
2. Loosen jam nut to allow cable adjustment nut to be
adjusted.
3. Turn cable adjustment nut clockwise to increase free-
play in the cable. Turn the adjustment nut counter-
clockwise to decrease free-play in the cable.
MD2346
4. There should be approximately 6 mm (0.25 in.) free-
play in the cable.
5. Tighten the jam nut to secure the adjustment; then
slide the rubber boot back into position.

Engine RPM (Idle)

 NOTE: To properly adjust the idle RPM, a tachome-
ter is necessary.
1. Set the brake lever locks. Start the engine and warm
it up to normal operating temperature.
CD589
Make sure the engine is fully warm before adjusting the
idle RPM.
Manual
Table of Contents
CAUTION
CD588
KM071A
49