Arctic Cat 2015 XR Service Manual page 102

 NOTE: When installed correctly, the sides of the
drive and driven gears will be flush with each other.
6. Install the clutch shoe assembly and secure with the
flange nut (threads coated with red Loctite #271).
Tighten to 221 ft-lb.
7. Install the clutch cover alignment pins into the crank-
case, apply oil to the cover gasket, and install the
gasket onto the crankcase.
8. Install the one-way clutch onto the clutch shoe
assembly.
100
CD985A
When installed correctly, the green alignment dot (or the
word OUTSIDE) on the one-way clutch is visible.
9. Lightly grease the clutch housing seal; then insert the
left fixed-drive spacer.
CD984
PR410A
10. Apply grease to the outer edges of the clutch hous-
ing; then from inside the clutch cover, install the
clutch housing into the cover using a rubber mallet.
11. Place the clutch cover/housing assembly into posi-
tion on the crankcase; then secure with the cap
screws making sure the different-lengthed cap
screws are in their proper location. Tighten to 8 ft-lb.
CAUTION
PR399A
CF088A
CF085A