Arctic Cat 2015 XR Service Manual page 75

4. From the left side, install the remaining crankcase
cap screws; then tighten only until snug.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs while tightening the
cap screws.
MD1008
5. In a crisscross pattern, tighten the 8 mm cap screws until
the halves are correctly joined; then tighten to 21 ft-lb.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
6. In a crisscross pattern, tighten the 6 mm cap screws
to 10 ft-lb.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.

After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Com-
ponents.
AT THIS POINT
CC871
73