Left-Side Components; Removing Left-Side Components - Arctic Cat 2015 XR Service Manual

33. If removed, install the spark plug. Tighten securely.

Left-Side Components

 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Left-Side
Components
A. Outer Magneto Cover
B. Water Pump
C. Cover
D. Rotor/Flywheel
1. Remove the four cap screws securing the outer mag-
neto cover to the left-side cover; then remove the
outer magneto cover.
2. Remove the flange nut securing the bushing to the
crankshaft; then remove the bushing. Account for the
O-ring inside the spacer.
3. Using a cold chisel, scribe a mark showing the rela-
tive position of the shift arm to the shift arm shaft to
aid in installing; then remove the shift arm.
88
CC001D
4. Remove the cap screws securing the speed sensor
housing to the crankcase and remove the housing
assembly; then remove the snap ring securing the
speed sensor trigger to the shaft and remove the trig-
ger. Account for the gasket.
 NOTE: It may be necessary to use a small two-jaw
puller to remove the trigger.
5. Loosen the clamps securing the coolant hose to the
water pump; then remove the crossover tube from
the cylinder head. Account for an O-ring.
6. Remove the two cap screws securing the water pump
to the engine; then remove the water pump.
7. Remove the cap screws securing the left-side cover
to the crankcase noting the location of the differ-
ent-sized cap screws for installing purposes.
8. Using an appropriate side case puller, remove the
side cover. Account for a gasket and two alignment
pins.
FI085A
CD920
GZ254