Arctic Cat 2015 XR Service Manual page 148

18. Remove the four cap screws securing the output
flange; then shift the differential assembly forward
enough to disengage the output flange assembly.
19. Place the differential on its right side; then remove it
from the frame.
Disassembling Input Shaft
 NOTE: This procedure can be performed on a rear
gear case; however, some components may vary
from model to model. The technician should use dis-
cretion and sound judgment.
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
146
CD016
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring.
Note the location of all the components for assem-
bling purposes.
XR169
3. Using a boot-clamp pliers (or suitable substitute),
KX159
remove the boot clamps; then remove the boots and
splined drive from the input shaft.
4. Remove the snap ring; then remove the input shaft
from the pinion housing.
GC004A
GC015
CD106