Arctic Cat 2015 XR Service Manual page 58

5. Using a 6 mm cap screw threaded into the fixed
driven face, spread the driven pulley by turning the
cap screw clockwise; then remove the V-belt.
6. Remove the fixed drive face.
56
MD1035
7. Remove the nut holding the driven pulley assembly;
then remove the driven pulley assembly.
MD1034
8. Using an impact screwdriver, remove the three Phil-
lips-head cap screws holding the air intake plate.
Remove the air intake plate.
MD1036
9. Remove the cap screws holding the clutch cover onto
the right-side crankcase half. Note the positions of
the different-lengthed cap screws for installing pur-
poses.
10. Using a rubber mallet, loosen the clutch cover; then
pull it away from the right-side crankcase half.
Account for two alignment pins and gasket.
KC132
MD1094
MD1068
MD1092