Genuine Parts; Preparation For Storage - Arctic Cat 2015 XR Service Manual

RECOMMENDED ENGINE/
TRANSMISSION OIL
CAUTION
Any oil used in place of the recommended oil could cause
serious engine damage. Do not use oils which contain
graphite or molybdenum additives. These oils can
adversely affect clutch operation. Also, not recommended
are racing, vegetable, non-detergent, and castor-based oils.
The recommended oil to use is Arctic Cat ACX All
Weather synthetic which has been specifically formu-
lated for use in this Arctic Cat engine. Although Arctic
Cat ACX All Weather synthetic engine oil is the only oil
recommended for use in this engine, use of any API certi-
fied SM 0W-40 oil is acceptable.
RECOMMENDED FRONT
DIFFERENTIAL/REAR DRIVE
LUBRICANT
The recommended lubricant is Arctic Cat Gear Lube or an
equivalent gear lube which is SAE approved 80W-90 hyp-
oid. This lubricant meets all of the lubrication requirements
of the Arctic Cat ATV front differentials and rear drives.
CAUTION
Any lubricant used in place of the recommended lubricant
could cause serious front differential/rear drive damage.
FILLING GAS TANK
! WARNING
Always fill the gas tank in a well-ventilated area. Never
add gasoline to the ATV gas tank near any open flames
or with the engine running. DO NOT SMOKE while filling
the gas tank.
Since gasoline expands as its temperature rises, the gas tank
must be filled to its rated capacity only. Expansion room
must be maintained in the tank particularly if the tank is
filled with cold gasoline and then moved to a warm area.
Tighten the gas tank cap securely after filling the tank.
! WARNING
Do not overflow gasoline when filling the gas tank. A
fire hazard could materialize. Always allow the engine to
cool before filling the gas tank.
4
Do not over-fill the gas tank.
When replacement of parts is necessary, use only genuine
Arctic Cat ATV parts. They are precision-made to ensure
high quality and correct fit. Refer to the appropriate Illus-
trated Parts Manual for the correct part number, quantity,
and description.

Preparation For Storage

Prior to storing the ATV, it must be properly serviced to
prevent rusting and component deterioration.
Arctic Cat recommends the following procedure to pre-
pare the ATV for storage.
1. Clean the seat cushion (cover and base) with a damp
cloth and allow it to dry.
2. Clean the ATV thoroughly by washing dirt, oil,
grass, and other foreign matter from the entire ATV.
OILCHARTJ
Allow the ATV to dry thoroughly. DO NOT get
water into any part of the engine or air intake.
3. Either drain the gas tank or add Fuel Stabilizer to the
gas in the gas tank. Remove the air filter housing
cover and air filter. Start the engine and allow it to
idle; then using Arctic Cat Engine Storage Preserver,
rapidly inject the preserver into the air filter opening
for a period of 10 to 20 seconds. Stop the engine.
Install the air filter and housing cover.
If the interior of the air filter housing is dirty, clean the
area before starting the engine.
4. Plug the exhaust hole in the exhaust system with a
clean cloth.
5. Apply light oil to the upper steering post bushing and
plungers of the shock absorbers.
6. Tighten all nuts, bolts, cap screws, and screws. Make
sure rivets holding components together are tight.
Replace all loose rivets. Care must be taken that all
calibrated nuts, cap screws, and bolts are tightened to
specifications.
7. Fill the cooling system to the bottom of the stand
pipe in the radiator neck with properly mixed cool-
ant.
8. Disconnect the battery cables; then remove the bat-
tery, clean the battery posts and cables, and store in a
clean, dry area.
! WARNING

Genuine Parts

CAUTION
CAUTION