Fuji Xerox ApeosPort-3 C4400 User Manual page 57

1
Remove any paper clips and staples before
loading the document.
2
Place the documents face up (when the
documents are 2-sided, place the front side
up) in the center of the document feeder.
Note • The indicator lights up when the
3
Adjust the movable document guides to
match the size of the document loaded.
Document Glass
The document glass supports a single sheet, a book, or other similar documents up to
297 x 432 mm (A3, 11 x 17 inches).
Important • After using the document glass, close the document cover.
The document glass automatically detects standard size documents. For non-standard
size documents, input the size in the [Original Size] screen.
For information on entering document sizes, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.82).
The standard document sizes that can be detected automatically depend on the [Paper Size Settings] in
the System Administration mode. For information on the paper size settings, refer to "5 Tools" >
"Common Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
1
Open the document cover.
Important • Ensure that a screen is displayed on the
document is loaded correctly. When the
indicator is not lit, the document glass is
detecting the documents. Press the
<Clear (C)> button and load the
documents again.
control panel, and then load a document.
If a document is loaded before a screen is
displayed, the machine may not properly
detect the document size.
Copying Procedure
Indicator
3
55