Fuji Xerox ApeosPort-3 C4400 User Manual page 187

F Code Method
When using the machine as the initiating station for performing Remote Relay
Broadcast, confirm the F Code and the password (if necessary) for the primary relay
station.
When using the machine as the primary relay station for performing Remote Relay
Broadcast, inform the initiating station of the F Code (sub-address) and the password
(if necessary) and confirm the F Code for the secondary relay station.
When using the machine as the secondary relay station for performing Remote Relay
Broadcast, inform the primary relay station of the F Code and the password (if
necessary).
Register the following information in the address numbers of the primary relay station
and the secondary relay station in advance.
Where
Primary
Relay
Station
Secondary
Relay
Station
* When the Speed Dial Extension Kit is installed, it will be 001 to 999.
Important • When using the F Code method for Remote Relay Broadcast, the primary relay stations and
Note • When performing Relay Broadcast with machines of this model, we recommend using the
When using the machine as a relay station, the F Code that is transmitted to the
initiating station is as follows.
Relay Broadcast
Relay Broadcast
The number of digits of the relay station ID:
1: When the relay station IDs and address numbers are two digits
2: When the relay station IDs and address numbers are three digits
Assign the initiating station either to an address number from 001 to 500* (when
the specification method for the initiating station is 3 digits in F Code) or to 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the address number to [On].
Assign the secondary relay station either to an address number from 001 to
500* (when the specification method for the initiating station is 3 digits in F
Code) or to 001 to 099 (when the specification method for the initiating station is
2 digits in F Code).
As the relay station ID, assign the last two digits of the Address Number for
the primary relay station that is registered to the secondary relay station.
As the broadcast recipients, assign the Address Number for the relay
recipients that have been registered to the secondary relay station.
Assign the primary relay station to the same address number as that of the
initiating station registered at the primary relay station, and set Relay Station
Setup of the address number to [On].
Assign the relay recipients either to an address number from 001 to 500* (when
the specification method for the initiating station is 3 digits in F Code) or to 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code).
secondary relay stations must support our F Code method and be equipped with the Relay
Broadcast feature.
fax signal method.
Print Primary
Directive Relay
Station ID
Up to 20 digits
Contents
Address Address Address
Number Number Number
Broadcast
4
....
185