Sidestand Switch Removal; Sidestand Removal; Sidestand Switch With Cable Strap - Buell XB9R 2003 Service Manual

Hide thumbs Also See for XB9R 2003:
Table of Contents

Advertisement

HOME
SIDESTAND
GENERAL
11
1
WARNING
If the side stand is not in the full forward position
when vehicle weight is rested on it, the vehicle could
fall over, which could result in death or serious injury.
Always park motorcycle on a level, firm surface.
Vehicle weight could cause motorcycle to fall over,
which could result in death or serious injury.
The sidestand is located on the left side of the motorcycle.
The sidestand swings outward to support the motorcycle for
parking.
The sidestand activates the integral sidestand switch which is
part of the starter interlock system. See
INTERLOCK
for more information.
INSPECTION
1.
Test the sidestand in the following manner. Without
motorcycle weight resting on it, side stand should move
freely into extended (down) and retracted (up) positions.
2.
Check sidestand switch (starter interlock) for proper
operation after the first 1500 miles (2400 km) and every
2500 miles (4000 Km) thereafter. See
INTERLOCK.

SIDESTAND REMOVAL

1.
Remove muffler. See
EXHAUST
SYSTEM.
2.
See
Figure 2-120.
Remove sidestand switch (6). See

SIDESTAND SWITCH REMOVAL

3.
Remove fasteners (2) securing sidestand bracket (3) to
frame.
WARNING
7.5 STARTER
7.5 STARTER
Muffler and Straps
in
in this section.
SIDESTAND SWITCH REMOVAL
1.
See
Figure 2-118.
2.
See
Figure 2-119.
wire attached, and pull switch assembly and wire har-
ness through to right side of vehicle.
3.
Remove sidestand assembly.
8712
Figure 2-118. Sidestand Switch with Cable Strap
8712
2.28
Figure 2-119. Sidestand Switch
Cut cable strap securing harness.
Remove sidestand switch, leaving
2003 Buell XB9R: Chassis
2.40
2-83

Advertisement

Table of Contents
loading

Table of Contents