Bearing Removal; Assemble Puller; Install Collet And Ball Bearing; Expand The Collet - Buell XB9R 2003 Service Manual

HOME
DISASSEMBLY

Bearing Removal

NOTE
On single disc wheels, always remove the brake disc side
first. If the wheel has two brake discs, remove the left bearing
first.
1. See Figure 2-7. Remove wheel bearings using BUSH-
ING AND BEARING PULLER (Part No. B43993-7) and
WHEEL BEARING REMOVER AND INSTALLER (Part
No. HD-44060).
2. Sparingly apply Extreme Pressure Lubricant (J-23444-A)
to the threads of the short forcing screw (1) to prolong
service life and ensure smooth operation.
i04277
4
3
2
1
1. Short forcing screw
2. Nut
3. Nice bearing
4. Washer
5. Bridge
Figure 2-7. Assemble Puller
3. Assemble the short forcing screw (1), nut (2), Nice bear-
ing (3), washer (4) and bridge (5) from the Wheel Bear-
ing Installer/Remover (HD-44060).
4. See Figure 2-8. Insert the Front Wheel Bearing Remover
Collet (B-43993-7) into the wheel bearing until it fully
seats against the bearing.
2-10 2003 Buell XB9R: Chassis
5
i04276
Figure 2-8. Install Collet and Ball Bearing
5. Insert the ball bearing into the collet.
6. See Figure 2-9. Thread the puller assembly (1) into the
collet (2).
7. Hold the collet (2), and turn the forcing screw (3) to

expand the collet.

i04278
1
1. Puller assembly
2. Collet
3. Forcing screw
Figure 2-9. Expand the Collet
8. See Figure 2-10. Place the bridge (1) against the wheel
hub.
9. Hold the forcing screw (2), and turn the nut (3) clockwise
until the bearing is free of the hub.
Collet
Ball bearing
3
2