Checking The Battery Chargers; Checking The Battery Modules - Varta element 3 Instruction Manual


If the current sensor value of one or multiple phases is 0
despite load, check the connection between battery
storage system and current sensor.

If necessary, replace the connection cable (RJ12 cable).

Check whether the current sensor board is correctly
connected.
11.2.8

Checking the battery chargers


On the System page, check the operating state of the
battery chargers for plausibility.
11.2.9

Checking the battery modules


The warnings and errors of the battery modules are
displayed on the System page.
Note: The individual modules are counted starting from 0, e.g. in
case of two modules, from 0 to 1.
94 Subject to alteration! Updated 11/2015