S.bus System Set-Up - GREAT PLANES GIANT BIG STIK XL 55-61cc/EP ARF Instruction Manual

S.Bus leads are available in a number of different lengths to
accommodate installation into any size airplane, regardless
of its complexity.
model and have some of it set up as S.Bus while other servos
are not using the S. Bus system. Something else to note is
that some of the S. Bus servos and receivers are HV, or High
Voltage, meaning that you could run a straight 2S LiPo for
your receiver battery.
Your system is not limited to programming only through the
SBC-1 channel changing tool and your transmitter. Utilizing the
USB interface, the CIU-2, you can do all of the programming
using your PC. Programming with this interface gives more
fl exibility and programming options than can be achieved
S.BUS SYSTEM
Battery
WING
Hub
Servo
There are many choices for the
S. Bus receivers; some are tiny
3-port receivers with others
being up to 18 channels. The 8
PWM outputs can be used as
you would normally set up a
model, allowing you to split the
Many ser vo choices are
available for use in a wide variety
of aircraft from micros to the
largest models.
S.Bus Receiver
Hub
Servo Servo
with any other radio system. To utilize standard, non-S.Bus
servos, you simply use the S.Bus decoder instead of the
S.Bus lead.

S.BUS System Set-Up

S.Bus Radio Equipment Recommendations
The S.Bus Setup will make the radio installation easier and
cleaner. It will also allow the servos to be powered directly
from the receiver battery, reducing any voltage drop through
the receiver. This manual will show the installation of the
S.Bus Set-up in the 55cc Big Stik ARF.
The following is required if using S.Bus servos.
❍ (1) S.Bus Receiver Futaba R7006SB (FUTL7673)
OR
❍ (1) S.Bus Receiver Futaba R7008SB (FUTL7675)
OR
❍ (1) S.Bus Receiver Futaba R6208SB (FUTL7668)
❍ (6) Futaba S3071HV S.Bus Servos (FUTM0717)
❍ (1) Futaba 6-Way Terminal Box (FUTM4199)
❍ (1) FSH-64 200mm Extension S.Bus Male to Male
(FUTM4664)
❍ (3) S.Bus Hub w/Cable 12" (300mm) (FUTM4195) (S.Bus
servo installation only)
❍ (2) Futaba Heavy-Duty Servo Extension 16" (FUTM4145)
(for aileron servos)
❍ (1) Heavy-Duty On/Off Switch (FUTM4390) (TACM2761)
Additional Items Required for Electric Motor Installation
❍ (1) 16" Futaba Heavy-Duty Servo Extension (FUTM4145)
(for ESC)
OR
❍ (1) 12" Servo Extension (TACM2093)
❍ (1) 3200mAh LiFe Receiver Battery (HCAM6446)
OR
(1) Castle Creations BEC 2.0 20A Max (CSEM1540)
❍ (1) 1" x 6" Adhesive-Backed Velcro (GPMQ4480)
Additional Items for Gas Engine Installation
❍ (1) 8" Futaba Servo Extension (FUTM4140) (for the
throttle servo)
OR
❍ (1) 6" Tactic Servo Extension (TACM2700)
❍ (1) Heavy-Duty On/Off Switches (FUTM4390)
(TACM2761) for ignition
5
Hub
Servo