Apply The Decals - GREAT PLANES ULTRA SPORT 46 Instruction Manual

5. Balance the propeller.
6. Install the prop and spinner.
7. Position the cowl.
8. Attach the Cowl.

Apply the Decals

1. The decals are die-cut from the factory.
2. Be certain the model is clean and free from oily
fi ngerprints and dust. Prepare a dishpan or small bucket
with a mixture of liquid soap and warm water – ½ teaspoon
of soap per gallon of water. Submerse one of the decals in
the solution and peel off the paper backing. NOTE: Even
though the decals have a "sticky-back" and are not the water
transfer type, submersing them in soap and water allows
accurate positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to
squeegee the remaining water from under the decal. Apply
the rest of the decals using the same method and allow to dry.
Make sure the model is securely held
whenever the battery is connected and
the propeller installed.
24