Removing And Replacing The 2 Lff Drive Backplane - HP ProLiant DL20 Gen10 Plus Maintenance And Service Manual

Removing and replacing the 2 LFF drive backplane

Removing and replacing the 2 LFF drive backplane
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove all inner rails from the chassis.
Retain all rails for future use.
8. Remove the access panel .
9. Remove the chassis ear .
10. Remove the front panel cover.
Retain the cover and all screws for future use.
Removing and replacing the 2 LFF drive backplane 91