Rear Swingarm Bearing Inspection; Rear Swingarm Bearing Removal; Rear Swingarm Bearing Installation - Suzuki Burgman UH125 Service Manual

8-52 CHASSIS

REAR SWINGARM BEARING INSPECTION

• Inspect the play of the bearing by finger while it is in the swin-
garm. Rotate the inner race by finger to inspect for abnormal
noise and smooth rotation.
NOTE:
If abnormal noise does not occur, it is not necessary to remove
the bearing.

REAR SWINGARM BEARING REMOVAL

• Remove the rear swingarm. ("8-36)
• Remove the dust seal 1.
& 09913-50121: Oil seal remover
#
The removed dust seal should be replaced with a new
one.
• Remove the bearing using the special tools.
& 09923-73210: Bearing remover (17 mm)
09930-30104: Sliding shaft
#
The removed bearing should be replaced with new
one.

REAR SWINGARM BEARING INSTALLATION

• Install new bearing using the special tool.
& 09913-70210: Bearing installer set (40 mm)
• Install new dust seal using the special tool.
& 09913-70210: Bearing installer set (35 mm)
• Apply grease to the lip of dust seal.
' 99000-25010: SUZUKI SUPER GREASE "A"
• Install the rear swingarm. ("8-36)
or equivalent