Malfunction Code And Defective Condition - Suzuki Burgman UH125 Service Manual

4-28 FI SYSTEM DIAGNOSIS

MALFUNCTION CODE AND DEFECTIVE CONDITION

DETECTED
DTC No.
00 NO FAULT
CKP sensor
12
P0335
IAP sensor
13
H
P0105
L
TP sensor
14
H
P0120
L
ECT sensor
15
H
P0115
L
TO sensor
23
H
P1651
L
DETECTED FAILURE CONDITION
ITEM
The signal does not reach ECM for 3
sec. or more, after receiving the starter
signal.
The sensor should produce following
voltage.
0.5 V sensor voltage < 4.85 V
In other than the above range, 13
(P0105) is indicated.
Sensor voltage is higher than specified
value.
Sensor voltage is lower than specified
value.
The sensor should produce following
voltage.
0.2 V sensor voltage < 4.80 V
In other than the above range, 14
(P0120) is indicated.
Sensor voltage is higher than specified
value.
Sensor voltage is lower than specified
value.
The sensor voltage should be the fol-
lowing.
0.15 V sensor voltage < 4.85 V
In other than the above range, 15
(P0115) is indicated.
Sensor voltage is higher than specified
value.
Sensor voltage is lower than specified
value.
The sensor voltage should be the fol-
lowing for 2 sec. and more, after igni-
tion switch is turned ON.
0.2 V sensor voltage < 4.7 V
In other than the above value, 23
(P1651) is indicated.
Sensor voltage is higher than specified
value.
Sensor voltage is lower than specified
value.
–––––––––––
CHECK FOR
–––––––––––
CKP sensor wiring and mechan-
ical parts
CKP sensor, lead wire/coupler
connection
IAP sensor, lead wire/coupler
connection
IAP sensor circuit open or
shorted to VCC or ground circuit
open
IAP sensor circuit shorted to
ground or VCC circuit open
TP sensor, lead wire/coupler
connection
TP sensor circuit shorted to
VCC or ground circuit open
TP sensor circuit open or
shorted to ground or VCC circuit
open
ECT sensor, lead wire/coupler
connection
ECT sensor circuit open or
ground circuit open
ECT sensor circuit shorted to
ground
TO sensor, lead wire/coupler
connection
TO sensor circuit shorted to
VCC or ground circuit open
TO sensor circuit open or
shorted to ground or VCC circuit
open