Suzuki Burgman UH125 Service Manual page 84

3-40 ENGINE
• Remove the snap ring A.
• Remove the bearing using the special tool.
$ 09913-70210: Bearing installer set (22 mm)
NOTE:
If abnormal noise does not occur, it is not necessary to remove
the bearing.
INSPECTION
Clutch shoe
• Check the boss and centrifugal weight fulcrum sections for
looseness, damage and operation.
• Check the clutch shoe for damage and fouling with oil on the
surface.
• Measure the thickness A of clutch shoe center area. If the
thickness is thinner than the service limit, replace the shoe
assembly with a new one.
% Clutch shoe thickness:
Service Limit: 2.0 mm
$ 09900-20102: Vernier calipers
Clutch housing
• Measure the inside diameter A of the clutch housing.
If the measurement exceeds the service limit, replace the
clutch housing with a new one.
% Clutch housing I.D.:
Service Limit: 125.5 mm