Suzuki Burgman UH125 Service Manual page 161

4-46 FI SYSTEM DIAGNOSIS
Step 2
1) Turn the ignition switch OFF.
2) Disconnect the ECT sensor coupler.
3) Measure the ECT sensor resistance.
$ ECT sensor resistance: Approx. 2.45 kΩ at 20 °C
! 09900-25008: Multi-circuit tester set
% Tester knob indication: Resistance (Ω)
Refer to page 7-10 for details.
Is the resistance OK?
• W/Bl or B wire open or shorted to ground, or
poor F or J connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
YES
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO Replace the ECT sensor with a new one.
"
When using the multi-circuit tester, do not strongly
touch the terminal of the ECM coupler with a needle
pointed tester probe to prevent the terminal damage
or terminal bend.
4) After repairing the trouble, clear the DTC using SDS tool.
(#4-26)
$ ECT sensor specification
Engine Coolant Temp
20 °C
50 °C
80 °C
110 °C
(Terminal – Terminal)
Resistance
Approx. 2.45 kΩ
Approx. 0.811 kΩ
Approx. 0.318 kΩ
Approx. 0.142 kΩ
2
2
ECM coupler (Harness side)