G 600/G 800
Appliance width [cm]
55/60 (full-size models)
Table 6-21: G 680, G 880 Water Hardness Settings
6.8.4.1.2
Checking the Water Hardness Setting
1. Access programming mode.
2. The Top solo LED will light up when the selector switch is turned to the set water
hardness (refer to Table 6-21).
3. Turn the program selector switch to Stop and switch the appliance off.
6.8.4.2
Service Mode 1
1. Switch off the appliance, close the door and turn the program selector to Stop.
2. Press and hold the Top solo button while switching the appliance on at the on/off
switch and wait until the Intake/Drain LED lights up (if this is not the case, repeat
Steps 1 and 2).
3. Select and start a program. The program sequence LEDs will show the program
step in binary code (see Table 6-22).
4. By pressing the Top solo button as appropriate, it is possible to advance through
the program step by step. If Top solo is not pressed, the steps will advance
automatically.
Note:
The program steps can be followed with a timing chart. The activation of electrical
components can be performed as the steps are advanced.
If the main switch or the door is opened, Service Mode 1 will be cancelled.
Display LEDs
Binary no.
Table 6-22: G 680, G 880 Program Sequence LEDs
The numbers in the binary row in Table 6-22 show the equivalent value of each LED.
The actual step number is indicated by the sum of the values of the lit LEDs.
Example:
"Wash" and "Drying" LEDs are lit: Binary codes 8 + 4 = Switching step 12.
Water hardness
1 - 4
5 - 6
7
8 - 10
11 - 12
13
14 - 16
17
18 - 22
23 - 35
36 - 47
48 - 65
66 - 70
Switching Step Display
Top solo
Softener
32
16
95
Technical Information
Program selector
switch position
(o'clock)
1
2
3
4
5
6
7
8
9
10
11
11
11
Wash
Drying
End
8
4
2
Water hardness
selector in
cabinet
6
6
6
6
6
6
6
6
6
6
4
5
6
Intake/Drain
1