Table of Contents
Advertisement
Before using for the first time
Setting the water hardness level
The display will change to the screen
for setting the water hardness.
- You should programme the
dishwasher to the correct water
hardness for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7 mmol/l (10 -
15 °dH - German scale) always
programme the dishwasher to the
higher value (2.7 mmol/l or 15 °dH in
this example).
In the event of a fault, it will help the
service technician if you know the
hardness of your local water supply.
Therefore, please enter the water
hardness:
____________°dH or mmol/l
The dishwasher is programmed at the
factory for a water hardness level of
2.5 mmol/l (14 °dH – German scale).
Set the water hardness level in your
area and confirm using OK.
See the "Settings" chapter, "Water
hardness" section for more
information.
26
Activating AutoDos
The display changes to the settings
screen for AutoDos (see "Detergent –
Automatic dispensing/AutoDos").
Even if you do not wish to use
AutoDos, you must remove the
transport locking device from the
PowerDisk compartment before
running the first programme
sequence (see "Detergent –
Activating AutoDos").
You can activate AutoDos.
If you do not wish to use AutoDos
(automatic dispensing), you can
manually dispense the detergent via the
detergent compartment (see "Detergent
– Manual detergent dispensing").
Select the setting you want and
confirm with OK.
This setting applies to all programmes
and can be changed at any time using
the AutoDos button.
Advertisement
Table of Contents
