Summary Of Dimensions; Electrical Information; Hard-Wired Electrical Connection; Table 1-1: Summary Of Dimensions - Miele G 600 Series Technical Information

G 600/G 800
1.4.3

Summary of Dimensions

Full-Size
Height
Width of machine
Width of opening
Depth
Depth w/door open
Slimline
Height
Width of machine
Width of opening
Depth
Depth w/door open

Table 1-1: Summary of Dimensions

1.4.4

Electrical Information

The appliance is equipped with a 4-foot power cord and molded NEMA 5-15 plug for
connection to a NEMA 5-15R receptacle (120VAC, 15-amp, 3-prong, grounded
outlet).
It is recommended that the power outlet for the appliance be installed on the wall
(within the cabinets), adjacent to under-counter space where the appliance is
installed.
Ensure that the cabinets contain no rough edges that could damage the power cord
or drain hose. If metal cabinets are used, ensure that a rubber grommet is installed
around the opening.
Always exercise caution when sliding the dishwasher in or out, to prevent damaging
the power cord and/or hoses.
1.4.5

Hard-Wired Electrical Connection

Connect L1 (black) to L on the terminal block, N (white) to N on the terminal block,
and GND to the ground connector.
Note:
Hardwiring the dishwasher should only be done if required by electrical code.
Do not cut the plug off the power supply cord/plug and connect it directly to the
house wiring under any circumstances. This voids the warranty.
For hardwiring, the power cord must be removed from the appliance by
disconnecting the cord from the terminal block located at the lower left front of the
dishwasher, behind the toekick and service panel. Feed the permanent power supply
cable through the strain relief and secure it directly to the terminal block.
Note:
The appliance must be grounded.
G 600 Series
32 ¼" to 34 ⅞"
23 ½"
23 ⅝"
22 ½"
45 ½"
G 600 Series
32 ¼" to 34 ⅞"
17 ½"
17 ¾"
22 ½"
45 ½"
17
Technical Information
G 800 Series
33 ⅛" to 35"
47 ½"
G 800 Series
33 ⅛" to 35"
47 ½"